The LTC3604 is a high efficiency, 4MHz synchronous buck regulator that incorporates a unique constant frequency/controlled on-time, current mode architecture. It can deliver up to 2.5A of continuous output current at output voltages as low as 0.6V from a 3mm x 3mm QFN or MSOP-16E package. Its current mode operation offers excellent line and load transient response even with high step-down ratios. The LTC3604 operates from an input voltage of 3.6V to 15V, making it ideal for applications powered from dual-cell Li-Ion battery stacks as well as 5V and 12V intermediate bus systems. Its switching frequency is user programmable from 800kHz to 4MHz, enabling the use of tiny, low cost capacitors and inductors. The LTC3604 uses internal switches with RDS(ON) of only 100mOhms and 130mOhms to deliver efficiencies as high as 95%. Its unique control architecture enables it to achieve duty cycles as low as 5% while maintaining switching frequencies as high as 2.25MHz, making it ideal for high step-down ratio applications, such as 12VIN to 1.2VOUT conversions. Burst Mode® operation is used to maximize light load efficiency, requiring only 300µA (at no load) and making the LTC3604 well suited for applications demanding maximum battery run time. For applications requiring the lowest possible noise, the LTC3604 can be configured to run in forced continuous mode, for minimum noise and potential RF interference. Additional features include a power good voltage monitor, output voltage tracking capability, and short circuit protection. The LTC3604EUD is available in a 3mm x 3mm QFN-16 and the leaded version, the LTC3604EMSE, is available in a MSOP-16E package. All versions are available from stock.
Summary of Features: LTC3604
3.6V to 15V Operating Input Voltage Range
2.5A Output Current
Up to 95% Efficiency
Very Low Duty Cycle Operation: 5% at 2.25MHz
Adjustable Switching Frequency: 800kHz to 4MHz
External Frequency Synchronization
Current Mode Operation for Excellent Line & Load Transient Response
User-Selectable Low Ripple (20mVP-P) Burst Mode® (No Load IQ = 300µA) or Forced Continuous Operation
0.6V Reference Allows Low Output Voltages
Short-Circuit Protected
Output Voltage Tracking Capability
Power Good Status Output
Available in Small, Thermally Enhanced, 16-Pin QFN (3mm × 3mm) & MSOP Packages
